Table of Contents
Advertisement
Operating
2.2
Control Panel
Access the web interface: http://"IP-address" and log-in.
The web page provides an overview of the switching state, as well as the external
sensor, provided that it is connected. W hen a single port is clicked at the IPower
Switch 4 DIN S Pro, a panel with buttons to control a single port appear:
The Port icon is green when the relay is closed, or red in the open state. An additional
small clock icon indicates that a timer is active. Timer can be activated by delay, reset
or batch mode.
An activated W atchdog is represented by an eye icon. An "X" means, that the address
that should be observed, could not be resolved. Two circular arrows show a booting
status.
The ports can be switched manually with the "On" and "Off" buttons. If the port is turned
on, it can be turned off by pressing the "Reset" button, until after a delay it turns itself on
again. The delay time is determined by the parameter Reset Duration, which is
described in the chapter "Configuration - Output Ports solves the panel again.
10
Advertisement
Table of Contents
