Lindy IPower Switch 4 DIN S Pro User Manual page 17

Table of Contents

Configuration

· Start the "GBL_Conf.exe" application

· Do a network search with the "Search" menu action

· In menu "Program Device" activate the item "Enter Firmware"

Factory Reset

If the device is in bootloader mode, it can always be put back to its factory default. All

TCP/IP settings are reset in this operation.

If a unit is set to factory defaults, an uploaded certificate or updated firmware will

be preserved.

1) via push button:

· Activate the Bootloader Mode of the device

· Hold down the button (or the "Select" button for devices with 2 buttons) for 6

seconds. If the push button is recessed, use a pin or paper clip

· The status LED will blink in a fast rhythm, please wait until the LED blinks slowly (about 5 seconds)

2) by Software:

Activate the Bootloader Mode of the device

"Start the GBL_Conf.exe" program

In menu "Program Device" activate the item "Reset to Fab Settings"

The status LED will blink in a fast rhythm, please wait until the LED blinks slowly

(about 5 seconds)

Table of Contents

32662