Configuring A Paging Key; Using The Paging Key - Mitel 6910 User Manual

LINE KEYS AND PROGRAMMABLE KEYS

CONFIGURING A PAGING KEY

MITEL WEB UI
Click on Operation > Programmable Keys.
1.
Programmable Keys
Select from Key 1 through Key 8.
2.
In the Type field, select Paging.
3.
In the Value field, enter a multicast IP address and a port number for the Paging key. When you press
4.
this key, the phone initiates an outgoing multicast RTP session to the specified address using the
specified port (e.g. 239.0.1.15:10000).
: The Value field allows for one multicast address entry only.
NOTE
To receive RTP steams for Group Paging, you must also configure the Paging Listen Addresses
5.
parameter at the path, Basic Settings > Preferences > Group Paging RTP Settings. For more infor-
mation about setting this parameter, see
Click Save Settings.
6.

USING THE PAGING KEY

The following procedure describes the use of the Paging key on the IP phone. The procedure assumes
you have already configured the Paging key using the Mitel Web UI.
:
NOTE
The recipient of a Paging call can set a global Do Not Disturb (DND) to ignore any incoming pages.
1.
For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is
2.
dependent on the Allow Barge In parameter setting and the Idling/On Call state.
IP PHONE UI
On the IP phone, press the key you configured for Paging.
1.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays.
Press the Drop key to end the multicast RTP session and return to the idle screen.
2.
"Group RTP Paging".
PAGING KEY
84