Mechanical Drawings; Mounting Considerations - Digi XBee-PRO 900 Instruction Manual

Oem rf modules

Table of Contents

XBee‐PRO® 900 OEM RF Modules

Mechanical Drawings

Mechanical drawings of the XBee‐PRO® 900 OEM RF Modules (antenna options not shown)

Downloaded from

Elcodis.com

electronic components distributor

The XBee-PRO® 900 RF Module (through-hole) was designed to mount into a receptacle (socket)

and therefore does not require any soldering when mounting it to a board. The Development Kits

contain RS-232 and USB interface boards which use two 20-pin receptacles to receive modules.

XBee‐PRO® 900 Module Mounting to an RS‐232 Interface Board.

The receptacles used on Digi development boards are manufactured by Century Interconnect.

Several other manufacturers provide comparable mounting solutions; however, Digi currently uses

the following receptacles:

• Through-hole single-row receptacles -

Samtec P/N: MMS-110-01-L-SV (or equivalent)

• Surface-mount double-row receptacles -

Century Interconnect P/N: CPRMSL20-D-0-1 (or equivalent)

• Surface-mount single-row receptacles -

Samtec P/N: SMM-110-02-SM-S

Digi also recommends printing an outline of the module on the board to indicate the orientation the

module should be mounted.

Table of Contents

Digimesh 900