Digi XBee-PRO 900 Instruction Manual page 30

XBee‐PRO® 900 OEM RF Modules
Start Delimiter
0x7E
Frame ID (Byte 5)
Identifies the UART data frame being reported.
Matches the Frame ID of the Remote Command
Request the remote is responding to.
Downloaded from Elcodis.com electronic components distributor
Remote Command Response
API Identifier Value: (0x97)
If a module receives a remote command response RF data frame in response to a Remote AT
Command Request, the module will send a Remote AT Command Response message out the UART.
Some commands may send back multiple frames--for example, Node Discover (ND) command.
Remote AT Command Response.
Length Frame Data Checksum
MSB LSB API-specific Structure 1 Byte
API Identifier Identifier-specific Data
0x97 cmdData
64-bit Responder
Address (bytes 6-13)
Indicates the 64-bit address
of the remote module that is
responding to the Remote
AT Command request
© 2008 Digi International, Inc.
16-bit Responder Network Address (bytes
14-15)
Set to the 16-bit network
Name of the command. Two
address of the remote.
ASCII characters that
Set to 0xFFFE if
identify the AT command
unknown.
Command Name (bytes
16-17)
Status (byte 18)
0 = OK
1 = Error
2 = Invalid Command
3 = Invalid Parameter
Command Data (byte 19-n)
The value of the requested
register.
30