Measurement Interface - UNI-T UTE310 Quick Manual

Quick Guide

6.2 Measurement Interface

6.2.1 Common Measurement
Pressing the [Meter] key to enter the common measurement interface. VIEW-1 has four test interfaces, the
first interface displays the voltage (such as RMS voltage, voltage calibration average value, voltage AC
component, voltage DC component, voltage positive peak value, voltage negative peak value); the second
interface displays the current (such as RMS current, current calibration average value, current AC component,
current DC component, current positive peak value, current negative peak value); the third interface displays
the power (such as average active power, apparent power, reactive power, positive peak value of average
active power, negative peak value of average active power, power factor); the fourth interface displays the
frequency, crest factor, phase and synchronizing frequency of measurement parameter.
The four display interfaces can be switched by the [
interfaces can also set a parameter as the main display parameter (displayed in blue background with large
font), which can be configured by the [CONFIG] key under the corresponding interface.
VIEW-2 can display multiple parameters at the same time.
Under VIEW-3 display style, mathematical operation can be carried out according to the user's demand,
supporting the display of four areas A, B, C, D. Each area can be set and displayed independently, and the
parameters displayed in A, B area can also be set to be displayed in the C area after arithmetic operation. The
fourth measurement interfaces is shown in the following figure.
VIEW-1
VIEW-1 and VIEW-2 displays the measurement parameter. VIEW-3 displays the measurement parameter
and mathematical operation results.
6.2.2 Harmonic Measurement
Pressing the [Harmonic] key to enter the harmonic measurement interface. The harmonic measurement has
two display modes, one is a bar graph (BAR) mode and the other is a list mode (LIST). It can measure the RMS
value/inclusion rate of each harmonic component from 1~50, and can also measure the total harmonic
distortion factor (THD). In the "SET" interface, the calculation formula of THD can be set to IEC or CSA, and
PPL source, harmonic analysis mode (Nor or IEC) and maximum harmonic analysis order (Order) can also be
set. The measurement interface is shown in the following figure.
Instruments.uni-trend.com
] or [ ] key, and each of the measurement
VIEW-2
UTE310 Digital Power Meter
VIEW-3
18 / 38