Lan Interface - UNI-T UTE310 Quick Manual

Quick Guide
The above wiring method only supports a PC with RS-232 interface. If the PC has no RS-232

interface, please use USB convert RS-232 serial line to connect a PC to UTE310.
This wiring method only supports SCPI.


8.2 LAN Interface

UTE310 is equipped with a LAN port, so the user can send commands to the power meter by LAN port. When
the power meter receives the command, the power meter will execute the function which corresponding to
the key on the front panel and return the measured and calculated data, the setting parameters and state
bytes of control panel and the error codes.
Port number
Interface type
Electrical and mechanical specifications
Transmission system
Transmission rate
Communication protocol
Support services
8.2.1 LAN Settings
1. Communication protocol: set the communication protocol of power meter to Modbus, the
setting method see subsection.
2. Selecting IP mode: DHCP (automatic acquire) or MANU (manually acquire).
Explanation
The user should correctly set the IP address, subnet mask and gateway for the power meter when the IP
mode is MANU.
8.2.2 PC Connect to UTE310 via LAN
PC Connect to a Single UTE310

Instruments.uni-trend.com
1
RJ-45
IEEE802.3
LAN (100BASE-TX, 10BASE-T)
Maximum 100Mbps
Modbus-TCP/IP
DHCP, Remote control (Modbus-
TCP/IP)
UTE310 Digital Power Meter
31 / 38