Getting Start; General Inspection - UNI-T UTE310 Quick Manual

Quick Guide

3. Getting Start

This chapter is to introduce the precautions and preparation for using the UTE310 digital power meter for
the first time.

3.1 General Inspection

Before using a new UTE310 digital power meter, it is recommended that you follow the following steps
to check the instrument.
3.1.1 Check for damage caused by transportation
If you find that the packing carton or the protective foam panel is badly damaged, contact your UNI-T
distributor for assistance.
3.1.2 Checking Accessories
Checking the packing list whether is damaged or missing. Contact your UNI-T distributor for assistance
if has any damage or loss.
3.1.3 Check the Instrument
Please contact your UNI-T distributor for assistance if you find the appearance of the instrument

is broken, or the instrument does not work properly, or fails the performance test.
If the instrument is damaged due to transportation, retain the packaging and notify the shipping

department and contact your UNI-T distributor for assistance.
3.1.4 Checking the Handle
The instrument's handle can adjust to four positions by appropriate strengths. Hold the handle and pull
to two sides to remove it. Adjusting the handle to the position as shown in the following figure.
1. Original position
3. Removal position
If the instrument's handle cannot adjust to four positions as above, please contact your UNI-T distributor
for assistance.
Instruments.uni-trend.com
2. Testing position
4. Lifting position
UTE310 Digital Power Meter
11 / 38