Table of Contents
Advertisement
This chapter contains information to help you solve issues. If the Industrial Managed Switch is not functioning properly, make
sure the Industrial Managed Switch was set up according to instructions in this manual.
The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of the Industrial Managed Switch
Some stations cannot talk to other stations located on the other port
Solution:
Please check the VLAN settings, trunk settings, or port enabled/disabled status.
Performance is bad
Solution:
Check the full duplex status of the Industrial Managed Switch. If the Industrial Managed Switch is set to full duplex and the
partner is set to half duplex, then the performance will be poor. Please also check the in/out rate of the port.
Why the Switch doesn't connect to the network
Solution:
Check the LNK/ACT LED on the switch
1.
Try another port on the Switch
2.
Make sure the cable is installed properly
3.
Make sure the cable is the right type
4.
Turn off the power. After a while, turn on power again
5.
1000BASE-T port link LED is lit, but the traffic is irregular
Solution:
Check that the attached device is not set to dedicate full duplex. Some devices use a physical or software switch to change
duplex modes. Auto-negotiation may not recognize this type of full-duplex setting.
Switch does not power up
Solution:
DC power cable not inserted or faulty
1.
Check that the DC power cable is inserted correctly
2.
Replace the DC power cable, if the cable is inserted correctly; check that the DC power source is working by
3.
connecting a different device in place of the switch.
If that device works, refer to the next step.
4.
If that device does not work, check the DC power source.
5.
User's Manual of IGS-4215-8T4X_IGS-4215-8UP4X
6. TROUBLESHOOTING
351
Advertisement
Table of Contents
