Table of Contents
Advertisement
Required Tools
17
Quick Start
Use this chapter as an abbreviated procedure for getting the module
into operation or as an overview if you need the additional steps
described in subsequent chapters. This chapter assumes that you
understand the following things:
• SLC 500 products
• Electronic process control
• Ladder logic instructions
Because this chapter is a start-up guide, it does not contain detailed
explanations. It does, however, refer to other chapters or to other SLC
publications for more information.
If you are unsure of terms used or concepts presented in this chapter,
always read the referenced chapters before trying to apply the
information.
This chapter describes:
• what equipment you need.
• how to install and wire the module.
• how to set up one channel for thermocouple input.
• the state of the LED indicators at normal start-up.
• the channel status word.
Have the following tools and equipment ready:
• Medium blade screwdriver
• Medium cross-head screwdriver
• Thermocouple or millivolt sensor
• Thermocouple extension wire (if needed)
• The module
• I/O chassis
• SLC processor and power supply
• Programming software
Chapter
Publication 1746-UM614B-EN-P - September 2007
2
Advertisement
Table of Contents
