❑ ⇒ Rep. gr. 46; Removing and installing brake shoes
3.3
Removing and installing brake shoes
Special tools and workshop equipment required
♦ assembly tool -T30114-
♦ brake drum calliper gauge -VAS 6787-
♦ pliers -T10623-
WARNING
Health hazard due to poisonous dust from brake system.
Risk of irreversibly deposited dust particles in the lungs. Risk
of respiratory health problems.
– Never blow out the brake system with compressed air.
Removal and installation are described for the left side of the
vehicle as an example.
Important
•
Do not operate the brake when the system is open.
Removing
– Remove wheel bearing unit ⇒ Running gear, axles, steering;
Rep. gr. 42; Wheel bearing assembly, trailing arm; Remov‐
ing and installing wheel bearing unit .
– Use assembly tool -T30114- -2- to remove retaining clips -1-
in direction of -arrow- . Press against pin from behind while
doing so.
– Lever brake shoe with parking brake lever -1- in direction of
-arrow A- off lower support -2- with aid of water pump pliers
-4- .
ID.4 2021 ➤
Brake system - Edition 07.2021
47
3. Rear brake