"Demo" Mode; Accessing The Demo Setting; Exiting Demo Mode - Electrolux 7 Series Service Manual

6 "DEMO" MODE

A special cycle is designed to demonstrate the operation of these appliances in shops, without connecting them
to the water mains. This way, any one of the programmes can be selected and, once the start button/sensor
has been pressed/touched (START/PAUSE), the appliance will only perform some of the phases of the
programme, skipping those which cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
the door lock is enabled regularly (door locked during operation, possibility of opening it at the end of the
cycle or when paused)
motor: all low speed movements are enabled, the pulses and spin are disabled,
the water fill solenoid valves and the drain pump are disabled.
display: since the cycle phases are very rapid (one second of the demo cycle corresponds to approximately
one minute of the actual cycle), the time left decreases by one unit every second. Keep in mind that the time
left does not always correspond to the actual cycle time.
6.1

Accessing the DEMO setting

SERIES 7
Do not start the procedure with the combination buttons pressed
1. Turn the appliance on at the ON/OFF switch
2. Turn the selector dial until the third LED in the right-hand row is on.
3. Press the START/PAUSE button and the nearest option button simultaneously (as shown in the figure).
4. Hold the buttons down (approximately three or five seconds) until "dEM" flashes for a short time.
6.2

Exiting DEMO mode

To quit the demo mode, unplug the appliance at the socket, because the ON/OFF button does not function.
2010 dmm
SERIES 8
30/96
SERIES 9
599 73 68-54