Demo Mode; Setting Demo Mode; Exiting Demo Mode - Electrolux AWF 1210 Service Manual

8 DEMO Mode

A special cycle has been created for demonstration of the operation of these appliances in retail outlets
without connecting the appliance to the water supply. In this way, the salesman can select any programme;
after starting the cycle by pressing START, the appliance will perform certain phases only, and will skip
those which cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
the door locking device is actioned in the normal way (i.e. the door remains locked while the appliance is
in operation, and can be opened at the end of the cycle or in pause mode)
motor: all low-speed movements are enabled, while the pulse signals and the spin cycle are excluded
the water fill solenoids and the drain pump are disabled
circulation pump (certain models only): this pump is normally disabled, but functions if water is
introduced manually until the anti-boiling safety level has been reached
display: since the phases of the cycle take place in rapid succession (1 second of the demo cycle is
equivalent to 1 minute of the actual cycle), the time-to-elapse decreases by 1 unit per second.
Remember that the time-to-elapse does not always correspond to the actual cycle time
alarms: for reasons of safety, the following groups of alarms remain enabled: E40 (door closed), E50
and E90 (communication between the boards/configuration).

8.1 Setting demo mode

Reset the running programme and switch the appliance off
Press button FABRICS (1) and button SPIN (3) simultaneously and then, holding them down, switch the
appliance on with button ON/OFF
Press and hold down the buttons for at least 4 seconds

8.2 Exiting demo mode

Switch the appliance off to exit the demo mode.
SOI/DT 2002-06 eb
55
599 35 27-25