Exiting Demo Mode - Electrolux 6 Series Service Manual

6 DEMO MODE
A special cycle is designed to demonstrate the operation of these appliances in shops, without connecting them
to the water mains:
−
The door closure device is activated normally.
−
All motor's low speed movements, the pulses and spin are disabled.
−
The water fill solenoid valves and the drain pump are disabled.
−
The display only shows set-up stage.
−
(START / PAUSE is disabled), because without the door the movement cannot be seen and is, therefore,
useless.
6.1 Demo mode settings
Do not start the procedure with the buttons in the combination pressed
Switch on the appliance using the
ON / OFF button.
Turn the selector to the third
position in styling 6 models and
until the third LED in the right-hand
row lights up in styling 7 models.
Press the START / PAUSE button
and the nearest option button
simultaneously (as shown in the
figure).
Hold the buttons down
(approximately three or five
seconds) until "dEM" flashes for a
short time.

6.2 Exiting DEMO mode

To quit the demo mode, unplug the appliance at the socket, because the ON / OFF button does not function.
Technical Support - A.D.L.
Series 6
21/83
Series 7
599 74 12-51 Rev.00