Demo Mode; Exiting Demo Mode - Electrolux washing machine Service Manual

8 DEMO Mode

A special cycle has been created for demonstration of the operation of these appliances in retail outlets
without connecting the appliance to the water supply. In this way, the salesman can select any programme;
after starting the cycle by pressing START, the appliance will perform certain phases only, and will skip
those which cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
the door locking device is actioned in the normal way (i.e. the door remains locked while the appliance
is in operation, and can be opened at the end of the cycle or in pause mode)
motor: all low-speed movements are enabled, while the pulse signals and the spin cycle are excluded
the water fill solenoids and the drain pump are disabled
display: since the phases of the cycle take place in rapid succession (1 second of the demo cycle is
equivalent to 1 minute of the actual cycle), the time-to-elapse decreases by 1 unit per second.
Remember that the time-to-elapse does not always correspond to the actual cycle time
alarms: for reasons of safety, the following groups of alarms remain enabled: E40 (door closed), E50
and E90 (communication between the boards/configuration).
Version with ON/OFF button
1. Cancel the set programme and switch the
appliance off.
2. Rotate the programme selector of two
positions clockwise.
3. Press the start/pause (8) button and any of the
option button simultaneously and then, keeping
them pressed, switch the appliance on
through the ON/OFF button (on/off).
4. Hold the start/pause and option buttons down till
the LEDs start flashing (about 5 seconds).
Attention: the programme selector is not always in the position indicated in the picture; it can be on the
right or on the left of the display board!

8.1 Exiting demo mode

Switch the appliance off to exit the demo mode.
SOI/DT 2005-01 dmm
Version with ON/OFF button incorporated in the
1. Cancel the set programme switching the
appliance off.
2. Press the start/pause (8) button and any of the
option button simultaneously and then, keeping
them pressed, switch the appliance on
rotating the programme selector of two
positions clockwise.
3. Hold the start/pause and option buttons down
till the LEDs start flashing (about 5 seconds).
35
selector
599 36 86 11