Table of Contents
Advertisement
3 SERIES 7
3.1
General characteristics
The EWM10931 electronic control system consists of two circuit boards plus the motor control system (inverter).
The control/display circuit board, inserted in a plastic
box, secured to the control panel (the figure illustrates:
the display circuit board with the side support plate onto
which the selector is secured, connected to one another
by a flat cable and the display circuit board assembly).
The main circuit board is positioned at the rear of the appliance and powers the electrical components as well
as communicating with the motor control board (Inverter) and receiving commands from the display board.
No. buttons
No. LEDs
Programme selector
Serial port
Power supply voltage
Washing type
Rinsing system
Motor
Spin speed
Anti-unbalancing system
Cold water filling
Hot water filling
Detergent dispenser
Control of water level in the tub
Door safety interlock
Heating element heat output
Temperature control
Buzzer
Sensors
Drum light
2010 dmm
maximum 8 (6 options + start/pause + ON/OFF)
maximum 20 + LCD
16 positions (incorporated in the circuit board)
DAAS-EAP communication protocol up to 115,200 baud
220/240 V
50/60 Hz (configurable)
Traditional with "Eco-ball" sphere
Jet-System
Traditional with "Eco-ball" sphere
Jet-System
Two-pole asynchronous (three-phase), with tachometric generator
400 ÷ 1,600 rpm
AGS
1 solenoid valve with 1 inlet – 2 or 3 outlets
1 solenoid valve with 1 inlet – 1 outlet
3 compartments: prewash/stains, wash, fabric softeners
4 compartments: prewash, wash, stain remover and conditioners.
Electronic/analogue pressure switch
Traditional (with PTC)
Instantaneous
1950 W with thermal fuses incorporated
NTC probe incorporated in the heating element
Traditional incorporated in the PCB
Water fill gauge (flowmeter from 2 ÷ 12 l/m)
Aqua control
LED
8/96
599 73 68-54
Advertisement
Table of Contents
