Electrolux 7 Series Service Manual page 92

13.4.6 Welded tub assembly
Remove the worktop (see relevant paragraph).
Remove the control panel (see relevant paragraph).
Remove the front panel (see relevant paragraph).
Remove the detergent dispenser (see relevant paragraph).
Remove the upper counterweight (see relevant paragraph).
Remove the front counterweight (see relevant paragraph).
Remove the back panel (see relevant paragraph).
To remove the washing unit assembly, disconnect:
All the tub pipes, the wiring connectors that connect the heating element, the NTC probe, remove the belt and the motor (to
lighten the tub).
Lay the appliance on its back (making sure you place a polystyrene or cardboard layer on the floor to prevent damaging the
cabinet).
Take the tub out of the washing machine
13.4.7 Tub suspension springs
• Left spring
Attach the spring as shown in the figure: the shortest leg towards the
crosspiece, whereas the longest leg towards the welded tub.
• Right spring
The instructions provided for the left spring also apply to the right spring.
When reattaching the springs (after repair work which required their removal), make sure that the bushings shown
in the figure are featured on both ends.
Pay attention to the differences between the bushings (see enlarged details).
Spare bushings are available, under the following codes:
Upper bushing code 405 50 62-51/9
Lower bushing code 405 50 62-52/7
Apply some grease on either end of the spring. Use grease
Code 5026 24 16-00/6
2010 dmm 92/96 599 73 68-54