Demo Mode Setting; Access The Demo Setting For Tc5 And Tc4 Styling; Access The Demo Setting For Tc3 Styling; Exiting Demo Mode - Electrolux EWM09311 Service Manual

8

DEMO MODE SETTING

A special cycle allows demonstration of the operation of these appliances in shops, in a user interactive
manner, without connecting them to the water mains:
♦ The interactive mode consists of selecting one of the programmes, adding any options and, once the start
button has been pressed, the appliance will only perform certain of the phases of the programme, skipping
those that cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
 The door lock is enabled as usual (door locked during operation, possibility of opening it at the end of the
cycle or when paused).
 Motor: all low speed movements are enabled, the pulses and spin are disabled,
 The water fill solenoid valves and the drain pump are disabled.
 Display: displays all the phases of the programme very quickly.
 Alarms: for safety reasons, the E40 (door closed), E50 (motor) and E90 (communication between
boards/configuration) families of alarms are enabled.

8.1 Access the DEMO setting for TC5 and TC4 styling

The operations listed below must be carried out within 7 seconds.
Do not start the procedure with your fingers over the combination sensors
1. Set the selector dial to position 0 (zero).
2. Turn the three position switch clockwise.
3. Simultaneously press the START/PAUSE button and the nearest option sensor
(as shown in the diagram).
4. Keep your finger above the sensors until:
The LEDs start flashing for the TC5 styling with the exception of the Start/Pause LED.
The flashing wording "DEM" appears on the display for the TC4 styling

8.2 Access the DEMO setting for TC3 styling

The operations listed below must be carried out within 7 seconds.
Do not start the procedure with your fingers over the combination sensors
1. Switch on the appliance using the ON/OFF button.
2. Turn the selector clockwise until the third LED lights up.
3. Simultaneously press the START/PAUSE button and the nearest option sensor
(as shown in the diagram).
4. Hold your fingers over the sensors (approximately three or five seconds) until "dEM" flashes
for a short time.

8.3 Exiting DEMO mode

To exit the demo mode, disconnect the plug from the power supply, because the ON/OFF pushbutton in the
TC3 styling and the rotation of the selector knob to position 0 (zero) for the TC4/TC5 styling have no function.
Technical Support - DMM
TC 5
TC 3
33/124
TC 4
599 75 58-67 Rev.04