13.6
Accessing the rear part
13.6.1 Back panel
Loosen the screws that fix it to the cabinet
13.7
From the back panel, you can access
1. Belt
2. Plastic pulley
3. Inverter
4. Motor
5. Heating
6. Aqua control
7. Rear shock absorber
13.7.1 Belt
Remove the back panel (see relevant chapter).
Take the belt, turning the pulley, and remove it.
When reassembling, position the belt onto the pulley as shown in the figure,
leaving two grooves free (as shown by the arrow in the figure).
13.7.2 Plastic pulley
Remove the back panel (see relevant chapter).
Remove the belt (see relevant paragraph).
Insert a retainer to secure the pulley in place.
Unfasten the screw securing the pulley to the drum shaft.
Tighten the screw at a torque of 60 Nm.
2010 dmm
94/96
2
1
5
7
3
4
6
599 73 68-54