Rapid Reading Of Alarms; Deleting The Last Alarm - Electrolux 7 Series Service Manual

8.3

Rapid reading of alarms

The last alarms can be displayed even if the selector is not in the tenth diagnostic position
or if the appliance is in normal operating mode (for example when performing a wash
programme):
→ Press the START/PAUSE button and the nearest option button simultaneously (as if you were entering
DIAGNOSTIC mode) for at least 2 seconds: the LCD display shows the last alarm.
→ The alarm continues to be displayed until a button is pressed.
→ The alarm reading system is as described in para. 8.2
→ During the time that the alarm is displayed, the appliance continues to perform the cycle or, if you
are in the programme selection phase, it retains the options selected previously in memory.
8.4

Deleting the last alarm

It is good practice to cancel the alarms stored:
•
after reading the alarm codes, to check whether the alarm re-occurs during the diagnostic cycle
•
after repairing the appliance, to check whether it re-occurs during testing
Series 7
1. Enter the diagnostic mode,
2. Turn the selector dial clockwise until the eleventh LED is turned on (in the left-hand alarm reading row)
3. Press/touch the START/PAUSE button/sensor and the nearest option button/sensor simultaneously (as
shown in the figure).
4. Hold down the buttons until the LCD display shows "E00" (at least 5 seconds).
N.B. With this operation all the alarms stored are deleted.
2010 dmm
Series 8
35/96
Series 9
599 73 68-54