Table of Contents
Advertisement
3.1.1.5
Pushbuttons – LEDs and LCD
The functions of each button are defined by the configuration of the appliance.
• Button no. 1: ON/OFF
This button is always included in all stylings.
− Press it to turn the appliance on. The buzzer concurrently plays a
melody (where enabled), the LCD display lights up (the
illuminated symbols are those of the programme).
− To turn the appliance off, press the button and hold it down for
approximately 1 second, after which time the buzzer plays a
melody (where enabled), the LCD display and LEDs are turned
off, all the options selected and any programme in operation are
cancelled.
The operation of the ON/OFF depends on the configuration of the
main circuit board. It can cut the appliance off from the electricity
mains completely (0 Watt circuit) or set the appliance to low energy
consumption mode (without 0 Watt circuit) in which case you will
need to take the plug out of the socket to cut off the electricity supply
completely.
•
Button no. 2: TEMPERATURE
This button is related to the part of the LCD display where the
temperature of the washing cycle is shown.
The initial temperature shown on the LCD display is that set for
the selected programme.
Press the button in sequence to lower the temperature. Once
the lowest temperature has been reached, the selection starts
off again from the highest one available for that particular
programme.
The temperatures available (displayed in °C) are:
95°C, 60°C, 50°C, 40°C, 30°C, 20°C, cold cycle.
The cold cycle is displayed by three dashes "
• Button no. 3: SPIN SPEED
This button is related to the part of the LCD display where the
spin speed of the washing cycle is shown.
The initial speed shown on the LCD display is that set for the
selected programme.
Press the button in sequence to lower the speed. Once the lowest
speed has been reached, the next one is "Rinse Hold" and the
related symbol lights up
programme), which is also lit during the "Extra Silent" programme.
The next selection will be the highest speed available for the
programme.
The spin speeds are: 1600–1400–1200–1000–800–600–400–
"Rinse Hold" cycle.
When no speed is selected, or the "Rinse Hold" cycle is selected,
the LCD display shows three dashes
"
".
- - -
•
Button no. 4: OPTION
This button is configurable and is related to LED (L1). Depending
on the configuration of the appliance, it can perform the option of:
− Stains
− HOT & COLD water filling
Press this button to enable/disable the option related to it, with
the respective lighting/turning off of LED L1. At the same time,
the programme time is updated (via the three digits).
2010 dmm
".
- - -
(where compatible with the selected
11/96
599 73 68-54
Advertisement
Table of Contents
