Table of Contents
Advertisement
B.1
Safety Precautions
The optical characteristics are measured under stable conditions at 25 °C/77 °F
(Room Temperature)
1.
The front polarizer is easily damaged, be very careful not to scratch it.
2.
Be sure to turn off the power supply when inserting or disconnecting from the
input connector.
3.
Wipe off water drops immediately. Long contact with water may cause discolor-
ation or spots.
4.
If the panel surface is soiled, wipe it with absorbent cotton or a soft cloth.
5.
The panel is made of glass, it may break or crack if bumped or dropped on a
hard surface.
6.
CMOS LSI is used in this module, be careful of static electricity and ensure you
ground yourself first before handling.
7.
Do not open or modify the Module Assembly.
8.
Do not press the reflector sheet at the back of the module in any direction.
9.
In the event that the module has to be returned to the packing container slot fol-
lowing removal, please grasp the far ends of the LED light bar reflector edge
softly, otherwise the TFT Module suffer damage.
10.
Do not to rotate or tilt the Interface Connector on the TFT Module when inserting
or removing the signal interface connector.
11.
After installing the TFT Module in enclosure, do not twist nor bend the TFT Mod-
ule. During integration of the enclosure, it should be taken into consideration
that no bending/twisting forces are applied to the TFT Module from outside. Oth-
erwise the TFT Module may get damaged.
12.
A small amount of materials with no flammability grade are used in the LCD
module. The LCD module should be supplied by power compliant with the
requirements of Limited Power Source (IEC60950 or UL1950), or be applied
exempt thereof.
IDK-1107WR-50WVB1 User Manual
28
Advertisement
Table of Contents
