Parallel/Perpendicular Parking Space Assistance Operation - Jeep GRAND CHEROKEE 4xe 2023 Owner's Manual

176 STARTING AND OPERATING
The outer surface and the underside of the front

and rear fascias/bumpers are clean and clear
of snow, ice, mud, dirt or other obstruction
NOTE:
If the vehicle is driven above approximately
15 mph (25 km/h), the instrument cluster display
will instruct the driver to slow down. If the vehicle
is driven above approximately 18 mph (30 km/h),
the system will cancel. The driver must then reac-
tivate the system by pushing the ParkSense Active
Park Assist switch.
When pushed, the LED on the ParkSense Active
Park Assist switch will blink momentarily, and then
the LED will turn off if any of the previously
described conditions are not present.
If the vehicle is in any other gear than DRIVE, and
an objected is detected, the system will default to
Parallel Park Exit. A prompt will appear in the radio
screen, and the driver will need to select "Yes" or
"No" for a Parallel Park Exit maneuver. Any other
conditions will result in a default to a Parallel
Parking maneuver.
P /P
ARALLEL ERPENDICULAR
S A O
PACE SSISTANCE PERATION
When the ParkSense Active Park Assist system is
enabled, you can select between Parallel,
Perpendicular, and Parallel Park Exit maneuvers in
the Uconnect system.
Choose Parking Maneuver Below
NOTE:
When searching for a parking space, use the

turn signal indicator to select which side of the
vehicle you want to perform the parking
maneuver. The ParkSense Active Park Assist
system will automatically search for a parking
space on the passenger's side of the vehicle if
the turn signal is not activated.
P
The driver needs to make sure that the selected
ARKING 
parking space for the maneuver remains free
and clear of any obstructions (e.g., pedestrians,
bicycles, etc.).
The driver is responsible to ensure that the

selected parking space is suitable for the
maneuver and free/clear of anything that may
be overhanging or protruding into the parking
space (e.g., ladders, tailgates, etc. from
surrounding objects/vehicles).
When searching for a parking space, the driver

should drive as parallel or perpendicular
(depending on the type of maneuver) to other
vehicles as possible.
The feature will only indicate the last detected

parking space (e.g., if passing multiple available
parking spaces, the system will only indicate the
last detected parking space for the maneuver).
While the vehicle is in DRIVE, there will be a full

screen image in the Uconnect display. If the
driver shifts to REVERSE while searching for a
parking space, a camera image will appear in
the Uconnect display with a "Shift To Drive"
message.