Jeep GRAND CHEROKEE 4xe 2023 Owner's Manual page 31

5. To stop the charging process, push the unlock
button on the key fob to unlock the charge
inlet, then disconnect the vehicle charge
connector first and then the Mode 2 Charging
Cable from the wall outlet. To disengage the
vehicle coupler, remove the connector from
the vehicle charge inlet.
Removing The Charge Connector From The
Vehicle Charge Inlet
6. Close the inlet door when a Mode 2 Charging
Cable is not connected to the vehicle.
NOTE:
The charging connector must be removed from

the charge inlet within one minute of pushing
the unlock button on the key fob, or the charge
inlet will relock and the vehicle will resume
charging.
It is good practice to keep the ignition in the OFF

position while conducting Mode 2 charging. This
minimizes any additional vehicle loads the
Mode 2 Charging Cable has to support. The
additional electrical loads will extend the high
voltage battery charging time.
In the event the Mode 2 Charging Cable does not
release from the vehicle, a manual release cable
can be found in the engine compartment. Pull the
cable straight out, toward the center of the vehicle
to release the Mode 2 Charging Cable.
Manual Release Cable
GETTING TO KNOW YOUR VEHICLE
Troubleshooting Using The Status
Indicator Display
If the vehicle is not charging properly, consult
the status indicator lights.
The Green LED signals correct operation of
the system.
The Red LED signals a failure in the charging
system.
The Yellow LED signals a failure with the outlet.
LED Indicator Lights
1 — Green LED
2 — Red LED
3 — Yellow LED
29
2