Download Print this page

Stop Operating - HOMCOM 821-025V70 Instruction Manual

Advertisement

!
Keep the cord away from doors and similar areas to avoid
damage.
!
Keep small children away from the appliance.

Stop operating

Press
again.
The 'mode select' indicator will turn off and the unit will stop operating.
Buzzer
Whenever any button is pressed, the buzzer will sound.
Ensure that one of the flaps is fully opened during operation. If the flap is
not opened completely, the overheat prevention device will activate - the
unit will stop operating.
After plugging in the unit or restarting it immediately after stopping, the
dehumidifying operation will start after approximately three minutes due
to the machine's protective function.
In the event of a power failure, the unit will automatically resume
operating in the mode it was in before the power failure.
The efficiency of the dehumidifier is affected by the air quality outside the
room. To maximise efficiency, try to avoid frequently opening and closing
the windows and doors.
To ensure proper performance, operate the dehumidifier within the usable
operating temperature range. For safety reasons, the dehumidifying
operation will automatically stop and switch to air cleaning mode if the
ambient temperature exceeds 32°C, When the operation starts, the
circulation of the refrigerant may cause some sound within the
dehumidifier. However, once the circulation stabilises, the sound will be
reduced
11

Advertisement

loading
Need help?

Need help?

Do you have a question about the 821-025V70 and is the answer not in the manual?

Questions and answers

TREVOR A CATTELL
January 16, 2025

How to adjust humidity settings

1 comments:
Mr. Anderson
February 3, 2025

To adjust the humidity settings on the HOMCOM model 821-025V70 dehumidifier:

1. Use the decrease (-) or increase (+) buttons to set the desired humidity level.
2. The LED display will show the selected humidity value.
3. Hold both the + and - buttons for three seconds to display the temperature value if needed.

This answer is automatically generated