Emptying water from the tank
1. Remove the tank from the dehumidifier.
2. Hold the tank by the handle and carry it gently.
3. Tilt the tank in the direction shown. Slowly empty the
water out of the tank.
4. Place the tank in the dehumidifier.
After the dehumidifying operation, water is
collected in the tank. When the tank is full, the
dehumidifier stops operating and the buzzer
will sound.
The buzzer sounds for 20 seconds if the tank
is taken out during use.
For continuous drainage, see page 12.
For timer Operation
Press the 'TIMER' switch to set the timer.
Press the 'TIMER' button to activate the timer function. The 'TIMER' indicator light will be on.
Before programming the timer, ensure the function is not already activated (the indicator light
should be off).
There are two available programmes:
a) Delayed power-off function (while the appliance is operating):
• The appliance will automatically stop once the set time is reached.
• Press the 'TIMER' button to set the desired time (ranging from 0-24 hours).
b) Delayed power-on function:
• The appliance will start once the set time is reached.
• Press the 'TIMER' button to set the desired time (ranging from 0-24 hours).
NOTE: The 'TIMER' light is on while programming the timer. Once the time reaches the set
value, the corresponding action (power-off or power-on) will take place accordingly.
10
Han dle
Han dle
Need help?
Do you have a question about the 821-025V70 and is the answer not in the manual?
Questions and answers
How to adjust humidity settings
To adjust the humidity settings on the HOMCOM model 821-025V70 dehumidifier:
1. Use the decrease (-) or increase (+) buttons to set the desired humidity level.
2. The LED display will show the selected humidity value.
3. Hold both the + and - buttons for three seconds to display the temperature value if needed.
This answer is automatically generated