Table of Contents
Advertisement
NOTICE
Make sure electrical supply matches voltage and frequency
rating on specification label. Incorrect electrical supply
may damage unit.
Hardwired Connection
Make the appropriate connections from the power cord to the
on-site power supply.
Plug Connection
Connect the proper plug to the power cord. Make sure the plug
is rated for the specific load and the plug matches a suitable
receptacle.
NOTE: The plug and receptacle must be grounded in
accordance with current standards.
General
Use the following procedure to operate HEATMAX Heated
Wells.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
NOTICE
Do not operate unit without water in well. Damage to unit
could occur.
Control Panel
The following are descriptions of the controls used to operate
the unit.
Power I/O (on/off) Button w/ LED
The Power I/O Button controls power to the unit. The LED
Indicator will illuminate green when the unit is on. The LED
Indicator will illuminate red when the unit is off.
Menu Button
The menu button allows adjustments of the holding temperature
between the following options.
• LOW: The temperature can be set between 40–65°C
(104–149°F).
• MID: The temperature can be set between 65–80°C
(149–176°F).
• HIGH: The temperature can be set between 80–95°C
(176–203°F).
Timer Button
The timer button allows adjustments of the timer. The timer can
be turned off or set between 1–180 minutes.
RCTHW2M_CN-0722
Auto-Fill Button w/ LED
The auto-fill button toggles between turning on and off the auto-
fill feature. When the LED Indicator is illuminated, the auto-fill
feature is on.
Hold/Heat Button w/ LED
The hold/heat button toggles between hold and heat mode.
• Hold Mode: The LED Indicator will illuminate yellow.
The display will show L 'XX'C, M 'XX'C, or H 'XX'C.
'XX' represents the current temperature of the unit.
• Heat Mode: The LED Indicator will illuminate red. The
display will show the HT XXC. 'XX' represents the current
temperature of the unit.
Up and Down Arrow Buttons
The up and down arrow buttons are used to make changes to
the settings.
Menu Button
Power I/O Button
Timer Button
9
INSTALLATION
OPERATION
Up/Down
Arrows
Hold/Heat Button
Auto-Fill Button
Control Panel
Advertisement
Chapters
Table of Contents
