Table of Contents
Advertisement
English
General
Use the following procedure to operate a Dry Soup Well.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage and
size electrical receptacle.
Do not move or relocate unit when it contains food
product. Turn off unit, remove food product, and allow to
cool completely before moving or cleaning.
NOTICE
Do not cook, warm, or hold food product directly in well
pan. Food product must be held in insert pan.
Touchscreen Control
The following are descriptions of the controls used to operate
SWC Series Dry Soup Wells. All controls are located on the
touchscreen control at the front of the unit.
This area shows current
temperature setting/product preset.
Touch this icon
Touch this icon
to put unit in
to put unit in
Hold Mode.
Hold Mode.
HOLD
REHEAT
Standby
Icon
Touch this icon to put
unit in Reheat Mode.
Touchscreen Control (showing the Hold Running screen)
Standby Icon
The Standby (
) icon toggles the unit between operation
and standby. In standby, the heating elements are off and
the touchscreen control display is dark, but the unit remains
energized.
• From standby, touch the
• From operation, touch and hold the
seconds to shut down operation and put the unit into
standby.
SWCM-1123
CAUTION
Touch this icon
Touch this icon
185°F
to lock/unlock
to lock/unlock
the screen.
the screen.
Touch this icon
to set a timer.
icon to turn on the unit.
icon for three
Hold Icon
Touch the Hold (
Hold Mode to hold preheated food product at a specific, food-
safe temperature. Hold Mode settings can be customized (refer
to the procedure in this section).
Reheat Icon
Touch the Reheat (
Use Reheat Mode to re-thermalize food product gently and
safely. Reheat Mode settings can be customized (refer to the
procedure in this section).
Timer Icon
Touch the Timer (
Hold or Reheat Mode. To use the timer, refer to the procedure in
this section.
Lock Icon
Touch and hold the Lock (
lock the touchscreen and prevent accidental or unauthorized
changes. To unlock the touchscreen, touch and hold the
icon for three seconds.
Service Icon
The Service (
protected Service screen. The Service screen allows
management and service technicians to access specific unit
settings, diagnostic/service information, and software update
functions.
Service
Icon
9
OPERATION
) icon to put the unit in Hold Mode. Use
) icon to put the unit in Reheat Mode.
) icon to set a custom timer during either
) icon for three seconds to
) icon provides access to the password-
Advertisement
Table of Contents
