Table of Contents
Advertisement
Tools Required for Setup
Have the following tools on hand and perform the replacement while referring to the diagram.
If there is no repair technician available, or if you do not have access to the required tools, please make the appropriate
request to our repair services department.
・ Required Tools
1.
Torque wrench- bit size 4 mm (5.0 Nm), bit size 8 mm (18.0 Nm)
2.
Phillips head (+) screwdriver- No.2
3.
Torque screwdriver- No.2 (0.8 Nm)
4.
Rag
5.
Solvent for wiping (something that has no effect on rubber, such as ethanol)
6.
Dust mask (for nose and mouth), gloves, protective eyewear
7.
Loctite 242
*Use items No.4 and 5 to wipe down any dirty area when replacing the part.
Part Replacement Procedure
Definition of Terms
In the replacement procedure, the terms "primary side" and "secondary side" shall be used to refer to specific locations.
Refer to the terms and diagram below when performing the replacement.
Exhaust tube
Suction tube
DA-60D
Exhaust tube
Suction tube
DA-120S
１１
Advertisement
Table of Contents
