Table of Contents
Advertisement
Knowhow is the difference
Maintenance instructions
General maintenance
Please follow these maintenance instructions to preserve the press's safety, performance and service
life.
• All moving parts must be inspected, cleaned and lubricated once a month using a moisture-
displacing and acid-free lubricant.
• Check the press for oil leaks and call an authorized service technician if required.
• In case of rust, remove the rust and protect with a rustproofing agent.
• Check that retaining rings, wire, nuts, bolts, and mandrels are intact and correctly mounted.
Cleaning
Ordinary cleaning with mild soap (i.e. dishwashing detergent, auto shampoo) and a soft brush.
Thorough drying will protect the press's painted surfaces.
NEVER wash the press using a high-pressure cleaner, as this may damage the press's surface and
components.
Storing the press
The press should always be stored in vertical position in a dry and temperate climate.
Repair
Any required repair of the press must be performed by a hydraulic expert.
Use of non-original parts may make the press unsafe for use and nullifies the warranty.
Therefore, use only original parts from Compac for reliable and safe operation.
Oil level
If it becomes necessary to refill oil in the press, see the section "Periodic maintenance and inspection",
and follow action 3A.
Oil information
Replace the oil as needed or at every 1-2 years.
Oil type: Castrol Hyspin AWS 32 or similar hydraulic oil with the same specifications.
Do NOT use brake fluid, motor oil or similar !
Monthly service
Check the oil level
The cylinder is self-lubricating.
Annual maintenance
Please see the section "Periodic maintenance and inspection" and complete the log book.
Disposal/destruction
Re-use the transport packaging if possible, or take it to a recycling center.
For service, drain the oil into an approved container and take it to the proper authority.
(EN)
21/31
2019-09-18 SN
EP100D G7 XXX (EN)_Midlertidig_SN.docx
Advertisement
Table of Contents
