Table of Contents
Advertisement
Component overview
Description of Operation
If the operating lever (H) is pulled up, then the piston goes back in the cylinder.
Raise/lower the table (N) into the working position using the winch (B), and place the pins (M) in the
holes in the press's chassis.
Place the v-blocks (A) so that they adequately support the object.
Place the object under the cylinder's piston (P).
Press the operating lever (H) down and actuate until the piston's pressure head (O) is directly above
the object.
Then continue pressing on the operating lever until the desired working pressure is built up and the
press work has been satisfactorily completed. It is possible to set the maximum pressure for the
operating lever (K).
To return the piston, pull up lever (H) and the piston movement will stop when the handle is released.
(EN)
EP100D G7 XXX (EN)_Midlertidig_SN.docx
Knowhow is the difference
Pos. Name
A
B
C
D
E.
F
G
H
I
J
K
L
M
N
O
P
Q
13/31
V-Block
Winch
Frame
Cylinder
Pressure gauge
Motor
Protective motor switch/
Electrical connection
Control lever up down
Inspection glass
Drainage plug
Pressure regulation
Oil container
Pin
Table
Compression and tension
flange
Piston
Oil filling
2019-09-18 SN
Advertisement
Table of Contents
