Knowhow is the difference
If the object is angled or asymmetrical, there is a significant risk of injury or damage to the press's
cylinder, piston or chassis (see Fig. 10).
Do not press on work items that could burst or break, because this can injure persons or damage the
press's cylinder, rod or frame. (see Fig. 11).
Fig. 9
Fig. 10
Fig. 11
3
4
2
V-Block or straightening plate
The v-blocks must always be used for support. (see Fig 12)
Fig. 12
Side movement of cylinder
For work-pieces which require more space between the press's vertical columns, it is possible to move
the cylinder out to the side/off-center. (see Fig. 13)
The cylinder's four bolts (1) are loosened with a 24 mm open-end wrench, and the cylinder can now be
moved to the desired position.
(EN)
17/31
2019-09-18 SN
EP100D G7 XXX (EN)_Midlertidig_SN.docx