Press Accessories - Compac EP 100 D G7 Operation Manual

Press accessories

The press can be ordered with the following optional accessories.
Optional Protective Guard
If there is a danger of objects or tools being ejected from the pressing area, then a protective guard
must be used or alternative protection which provides the same level safety.
Shelf
system
Shelf system
The shelf system is designed for storage of the other accessories and is hung loose at the top, on the
left side of the press's chassis.
Ball bearing set
The press's standard pressure head is removed by unscrewing the small finger screw and pulling out
the pressure head. The set comes with a pressure head adaptor, which replaces the standard pressure
head/nose.
Mount the accompanying mandrel in the adapter and secure it with the small screw on the side of the
adaptor.
The accompanying press blocks are selected based on the bearing to be pressed.
Place the block over the ball bearing and center it together with the pressure rod. The ball bearing is
now ready to be pressed in or out.
(EN)
EP100D G7 XXX (EN)_Midlertidig_SN.docx
Mandrel Ball bearing
set set
29/31
Knowhow is the difference
Press plate
2019-09-18 SN