Table of Contents
Advertisement
NOTE: Because the table hangs freely from the winch during positioning, there is a risk of
the table falling and causing damage or injury. Therefore, do not release the handle until
one of the winch's locks is engaged with the turntable (see Fig. 4) before removing the pins.
Preparation of press table and v blocks
1.
The table must be placed as close to the returned rod as possible, so that the piston always has
the least possible projection (the shortest possible stroke length). In this way, the stress during the
pressing operation will be minimised, reducing the risk of damage to the press cylinder, piston or
frame.
2.
It is important that the pins are placed correctly and that the piston is perpendicular (not off-center)
to table/plate (see Fig. 7) for proper use/set-up. The table must be correctly supported by both pins
before the press can be used.
Mount the pins as shown in Fig. 7, with the washer between the table and frame, and the piston should
press perpendicularly on the object. If the pins are located incorrectly, with the washer outside the table
as shown in Fig. 8, then there is a significant risk of serious damage or injury.
Positioning the object/work-piece
Place the object (4) so that the piston (3) is perpendicular and centered in relation to and the table/plate
(2) (see Fig.9). The object should not move during the pressing operation.
(EN)
EP100D G7 XXX (EN)_Midlertidig_SN.docx
Fig. 7
Knowhow is the difference
16/31
Fig. 8
2019-09-18 SN
Advertisement
Table of Contents
