Transport And Installation Of The Press; Press Transport - Compac EP 100 D G7 Operation Manual

Transport and installation of the press

RISK OF TIPPING OVER
With regard to safe transport of the shop press, please be aware that the press's center
of gravity is very high.
When shipped, the press is secured to the transport pallet with screws and metal strips,
which should only be removed when setting up the press.

Press transport

Failure to observe the instructions below can result in serious damage and injury
1. With a forklift: Place the forks under the top frame. The lifting points are marked on the transport
packing material. (see Fig. 1).
2. With a crane: Use only approved hoisting straps with a capacity of at least the total weight of the
press.
Note: mount the straps only at the top of the press, and protect them from sharp edges.
On receipt of the press:
Check the packing material and the press for visible damage, cracks and leakage.
The carrier must be notified of any damage occurring during transport.
Installation of the press:
The press must be secured to the floor using expansion bolts, for safe and stable installation.
(EN)
EP100D G7 XXX (EN)_Midlertidig_SN.docx
Fig. 1
This lifting instruction is printed on the
transport packing material at the top of the
press.
LIFT HERE
CAUTION ! – THE PRESS IS TOP HEAVY
THE PRESS MUST BE FIRMLY SECURED
WITH STRAPS ON THE VEHICLE
Knowhow is the difference
14/31 2019-09-18 SN