Operation Of The Press - Compac EP 100 D G7 Operation Manual

Operation of the press

Adjust the table to the required work height, and then place the v-blocks upon the table.
Note! At pressures over 40% of the maximum capacity both v-blocks must be supporting the object.
Pull the operating lever (H) up so that the piston moves returns to its start position.
Raise/lower the table (N) to the required working position using the winch (B), and then place the pins
(M) in the holes which are in the press's frame.
Place the v-blocks (A) so that they adequately support the workpiece.
Place the workpiece underneath the cylinder's piston (P).
Press the operating lever (H) down until the piston's pressure head/nose (Q) is directly above the
workpiece.
Then continue pressing on the operating lever until the required working pressure is reached and the
press work has been satisfactorily completed. It is possible to set the maximum pressure for the
operating lever (K).
Never use the press without the pressure head/nose mounted, as in doing so will damage the piston.
Return
To return the piston, pull handle (H) up, and the piston movement will stop when you let go of the
handle.
WARNING! Do not exceed the maximum pressure and maximum stroke, as this can
damage the cylinder's seals. Therefore, ensure that the pump's handle is always released
when the press has reached the full stroke length.
(EN)
EP100D G7 XXX (EN)_Midlertidig_SN.docx
Knowhow is the difference
20/31 2019-09-18 SN