Setting The Base Parameters - urmet domus iPercom MIKRA2 1060 Installation And Configuration Manual

Kit ip e ipercom 7” basic, kit ip with and basic 7” ipercom
Hide thumbs Also See for iPercom MIKRA2 1060:
Table of Contents

Advertisement

Available languages

Available languages

The following page will appear:
Figure 8: Creating a new configuration
6.4.1

SETTING THE BASE PARAMETERS

On the create configuration page, select the type of Villa Kit project (single family) and then assign a meaningful name to the project and an installer's
password.
Figure 9: New configuration setting
To allow future modifications of the configuration created, it is recommended that the installer password be noted and saved in a safe place.
Once the OK button is pressed, an empty configuration will be created and a page will appear where it is possible to add the individual devices to the
configuration and configure them.
Figure 10: Basic configuration
The section highlighted to the left is the NAVIGATION MODULE and makes it possible to add devices by positioning the cursor on the apartment or in the
floor desired.
33
DS1060-179

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iPercom MIKRA2 1060 and is the answer not in the manual?

This manual is also suitable for:

Ipercom mikra2 1060/634

Table of Contents