Administrative Requirements Prior To Mfp Http Setup; Mfp Specific Requirements - Konica Minolta bizhub PRO C5500 Setup Instructions

A. Administrative Requirements Prior to MFP HTTP Setup
The MFP's HTTP settings and Server addresses MUST be obtained prior to
setting up the MFP for HTTP Communication.
B. MFP Specific Requirements
The technician performing the HTTP setup must have the following information from
the vCare administrator before visiting the customer:
1. Device ID: The Device ID for MFP must match the 13 digit ID configured on
CSRC Server. The Device ID is the serial number for the MFP. This setting is
hard-coded in the bizhub PRO C5500/C5501 and C6500/C6501 vCare/CSRC
settings
2. Center ID: This ID is used by the vCare/CSRC Communication Server.
3. WEB/DAV Server IP Address: The IP address for the WEB/DAV Server.
4. HTTP Port: Typically 80, unless otherwise indicated.
5. Service Engineer's ID number: The SE ID is a seven-digit number. It should be
unique to the technician servicing the machine. Enter leading zeros if required;
e.g. 0123456. If no numeric ID assigned, simply use: 1234567.
Note: In order to enable HTTP communication for the C5500/C6500 minimum ver.40
FW is required. When security enhanced mode is set to ON, the use of the Main Body
NIC for vCare/CSRC is not possible.
Konica Minolta bizhub PRO C5500/C5501, C6500/C6501 Main bizhub vCare HTTP Setup Guide
Page 2 of 18