Table of Contents
Advertisement
1-2
Introduction
•
The FM and HD/DAB+ processed signals can be monitored remotely via IP, allowing for processing adjustments
where a clean over-the-air signal isn't available.
•
Optional µMPX (micro MPX) allows transmission of DMPX over IP.
•
High resolution front panel touch screen for ease of navigation.
Input/output Configuration
THE OPTIMOD-5750 will simultaneously accommodate:
•
Digital AES3 left/right inputs.
•
Two Digital AES3 outputs, both of which can be switched independently to carry the following signals: FM analog
processed without diversity delay, FM analog processed with diversity delay, digital radio processed without
delay, digital radio processed with delay, or low delay monitor.
•
Digital AES11 sync reference input.
•
Analog left/right inputs.
•
Analog left/right outputs, which can be switched independently to carry the following signals: FM analog
processed without diversity delay, FM analog processed with diversity delay, digital radio processed without
delay, digital radio processed with delay, or low delay monitor.
•
Analog and AES3 composite stereo outputs.
•
Subcarrier (SCA and RDS/RBDS) input.
•
Dante dual-redundant audio-over-IP left/right inputs and outputs, 44.1 or 48 kHz.
Digital AES3 Left/Right Input/Outputs
The digital input and outputs conform to the professional AES3 standard. They all have sample rate converters to
allow operation at 32 kHz, 44.1 kHz, 48 kHz, 88.2 kHz, and 96 kHz sample frequency. For best peak control, operate
at 44.1 kHz or higher.
The left/right digital input is on one XLR-type female connector on the rear panel; the left/right digital outputs are
on two XLR-type male connectors on the rear panel. THE OPTIMOD-5750 simultaneously accommodates digital and
analog inputs and outputs.
You can switch any of the 5750's outputs between the analog-channel processing, a low-delay monitor signal, and
the HD-channel processing. You select whether THE OPTIMOD-5750 uses the digital or analog input on the
Input/output screen, by PC remote control, or by GPI (General Purpose Interface) optically-isolated remote control.
Advertisement
Table of Contents
