3-44
Operation
SILENCE DETECT
•
INPUT FALLBACK – When the main input fails, the 5750 will switch to the selected input on this screen. The
options are ANALOG, Digital 1, Digital 2, AoIP 1, AoIP 2, or Stream.
•
SILENCE THRESHOLD – Sets the level at which all input audio below will start the silence delay clock. If audio
remains below this level longer than the silence delay time is set, the 5750 will switch to the selected backup
audio source. The level range is -20dB to -60dB. For classical and jazz formats, a lower threshold is suggested.
•
SILENCE DELAY – Adjustable from 2 seconds to 60 seconds (1 minute). If audio remains below the level selected
in the SILENCE THRESHOLD setting for longer than the period of time set here, the 5750 will switch to the INPUT
FALLBACK source.
If your input levels and modulation are set, it is time to pick a preset and adjust the sound. The following pages
will guide you thru the various adjustments and what they mean to achieving your signature sound. You can
follow along with the processing tabs from left to right.
PROCESSING PARAMETERS
The processing parameters tab opens up a sidebar which allows the user the ability to fine tune each stage of the
audio. The following section of this manual will walk you through the steps and help you understand what the
various controls mean.
LESS-MORE
As you increase the setting of the L
processing artifacts will increase. Please note that the highest L
unpleasant distortion and processing artifacts! This helps assure you that you have chosen the optimum setting of
the L
-M
control, because turning the control up to this point will cause the sound quality to become obviously
ESS
ORE
unacceptable.
You need not (in fact, cannot) create a sound entirely from scratch. All User Presets are created by modifying Factory
Presets, or by further modifying Factory Presets that have been previously modified with a L
is wise to set the L
-M
ESS
ORE
-M
control, the air sound will become louder, but (as with any processor)
ESS
ORE
control to achieve a sound as close as possible to your desired sound before you make
-M
setting is purposely designed to cause
ESS
ORE
-M
adjustment. It
ESS
ORE