Table of Contents
Advertisement
Orban 5750 Technical Manual
USING TELNET TO CONTROL TERMINAL SERVER
You can control RDS from Windows directly via the Windows Telnet command line utility or the free utility PuTTY.
A) Open the Windows Telnet client by typing telnet into the Windows Run box in the Start menu and hitting the
Enter key on your keyboard.
In Windows 7 and higher, you must enable the Telnet client; it is not enabled
by default. If you do not know how, use a search engine to find out. The general
idea is to navigate to C
check "Telnet."
B) Connect the Telnet client to the OPTIMOD by typing open [IP address] [IP
Port], where [IP address] is the IP address of the OPTIMOD and [IP Port] is
the IP Port you assigned to the OPTIMOD RDS terminal server in System.
C) You may now type any of the terminal commands in the chart of RDS Terminal
Commands below.
P
> P
ONTROL
ANEL
ROGRAMS
> T
W
F
URN
INDOWS
EATURES
3-31
Operation
O
O
and
N OR
FF
Advertisement
Table of Contents
