Table of Contents
Advertisement
•
Always start the engine on a flat and clean surface, without stones or sand. During all
phases in which the engine is kept running near the ground (such as heating, take off,
landing) it is necessary to maintain a safe distance from the engine. A good safety
distance is 100 meters in every direction.
The following engine speed limits must be respected to avoid engine failures, to keep
the warranty valid and to have a correct maintenance scheduling according to the
Vittorazi program:
•
Do not keep the engine at full revs for more than 60 seconds.
•
Do not keep revs higher than 7.000 RPM during long cruising flights or long climbs.
The average power delivered by the engine during a flight should remain below the
indicated threshold. Contact the aircraft manufacturer for further clarification.
The temperature limit of CHT is 208° Celsius. Do not persist above this temperature
threshold, engine overheating and irreversible damage could occur.
When the CHT exceeds 208°C, the ECU system generates a small engine speed reductions
that last a fraction of a second, without compromising the flight dynamics, just to call the
pilot's attention. This safety function disappears when the speed is reduced below 7400 rpm.
Exceeding the EGT limit is shown on the display with the word "Temp" flashing in the top
right corner. Proceed at reduced power and once on the ground contact your dealer.
LiPo batteries are high-tech products but potentially dangerous to property, animals or
people, especially if used improperly or without experience.
Moster 185 EFI - Installation manual – V1/2024
7
Advertisement
Table of Contents
