Table of Contents
Advertisement
The extra-cooling profile propeller approved from Vittorazi, needs a spacer between the hub
and the propeller. The only spacer authorized for this motor is the one designed and
produced by Vittorazi (M120 code in the Illustrated Parts Catalogue). Spacers made with
wrong measures or geometries, non-compliant materials, make the engine dangerous and
void the warranty.
Propeller screws tightening values:
•
Carbon-fibre propeller: 10-12 Nm on each screw M6.
Ask an authorized dealer or the instructor, if you are not sure about the propeller assembling.
It is very important to check the tightening of the propeller screws before take-off and
after landing.
Be sure that the screws are suitable to the propeller in use: the thread of the screws is
inserted in the hub for at least 12 mms for carbon propellers.
Moster 185 EFI - Installation manual – V1/2024
48
Advertisement
Table of Contents
