Battery - Vittorazi Motors MOSTER 185 EFI Installation Manual

3.4 Battery

The Vittorazi batteries are composed by 4 LiPo cells connected in series, with a capacity of 3300
mAh and a voltage of 14.8 V, contained inside an aluminum box.
The electrical circuit is protected by two fuses, a 15 A pico-fuse and a 60 A fuse.
There are two cables coming out of the battery: the ECU power cable (SQUBA 3.6 connector) and
the starter power cable (XT60 connector).
The battery is turned on and off by the switch located on the top front.
When the battery is switched on, a green flashing LED lights up.
For installation, the PPG frame must be equipped with a battery support that allows the
battery to be fixed and secured in place with the Velcro holder provided by Vittorazi.
For safety reasons, the battery must be placed in a position that can be reached safely by the
pilot during flight, as far as possible from any source of heat and possible impacts and on the
opposite side from the fuel inlet.
Moster 185 EFI - Installation manual – V1/2024 24