Digigram ALP-Dante User Manual page 30

User Manual for ALP-DANTE
the Primary Network and the Secondary Network. To set up and use Dante Redundancy,
connect your redundant Dante-enabled device using duplicate network switches and
Ethernet cables as shown below. Connect the following to the Primary Network only:
● Any computers running Dante Controller
● Any non-redundant Dante-enabled devices
All Dante-enabled devices that support redundancy should be connected to
both the Primary and Secondary networks. The primary and secondary
networks MUST NOT be interconnected at any point.
1. Make sure all computers are set to automatically configure their IP address.
2. Power on the network switch.
3. Connect your Primary Ethernet cables from each device to the Gigabit ports of the
Primary network switch.
4. Connect your Secondary Ethernet cables from each device that supports redundancy
to the Gigabit ports of the Secondary network network switch.
30