UpDown Desk PRO Series Install Manual page 6

09
Take one of the constructed leg pieces and position it over one side of the
threaded insert holes of the desktop.
Using M6 x 12 screws and the smaller Allen Key with the ball on the end, loosely tighten
the screws into the insert (not too tight just yet).
10
Take the two inner rails that you
removed from the sliding rails
and slide them into the outer
tubes that you fastened to the
desktop.
11
Take the other constructed leg
piece and complete the same
as you did above, ensuring
that you slide the inner rails
into the outer tubes of the leg
you are now fixing.
M6 x 12mm
Outer Tube
Inner Rail
06