UpDown Desk PRO Series Install Manual page 9

16
You will now install the Control Box
(f) and Control Panel (e).
Installing the Control Box (f), it is
advised that you plug it into the leg
that is on the same side as you are
wanting the Control Panel (e) to be.
Please ensure that the Control Panel
Port is facing that same Leg.
Once you have that plugged into
the leg, you can go ahead and use
two Self Tapping screws to fix the
Control Box (f) onto the desk, using
either the Phillips head screwdriver
or the power drill.
NOTE: WE RECOMMEND THAT THERE
IS SOME SLACK IN THE CABLE, AS IF IT
IS PULLED TOO TIGHT, THIS MAY
CAUSE DAMAGE OR INCONVENIENCE
WHEN IT COMES TO UNPLUGGING
THE LEG AT ANY STAGE.
17
Once the Control Box (f) has been
fixed you can plug in the other
Connection Motor Cable (g) be-
tween the opposite Leg and Control
Box
Self Tapping
09