UpDown Desk PRO Series Install Manual page 5

07
Aligning the back plate on the leg with the two centralized holes in the wing.
Using the M8 x 10mm screws provided, fasten the Leg (a) to the Wing (b).
Then fasten the two Outer Rails from the Sliding Rails to either side of the Leg.
Make sure the anchor points are facing out.
Repeat this step with the other Leg, Wing and Outer Rails.
08
Once you have constructed both the leg pieces. Unwrap the desktop and please inspect
both sides to decide which way you want your desktop positioned on your frame.
Place a piece of protective cloth or towel on the ground and then place the desktop
face down, so you can attach the frame to the underisde of the desktop.
Anchor Points
05