UpDown Desk PRO Series Install Manual page 12

CONTROL PANEL OPERATIONS
Up & Down Memory Display Screen
The PRO Series desk can be raised manually by pressing the Up/Down buttons or
alternatively by pressing pre-set heights using the M1 – M4 buttons.
To set a height on any given 'M' button, use the Up/Down buttons to achieve your desired
position. To store this height, press and hold an M button for 5-6 seconds until you hear a
beep.
The display screen will show your current height. It is pre-set from the factory to show the
lowest height at 64cm, which is measured to the top of a standard 2.5cm thick desktop.
This can be adjusted in the event you install a thicker desktop or castor wheels to your
frame.
The desk has a built in 'anti-collision' safety feature whereby any interference or severe
resistance experienced automatically stops the up/down movement of the desk and
rebounds it a small amount. The sensitivity for this can be adjusted.
If you notice the desk has gone to sleep - no numbers are being displayed on the control
panel - you can wake it up with either the arrow buttons or any one of the 'M" Buttons.
12