UpDown Desk PRO Series Install Manual page 11

21
This step may require the assistance of someone else. You need to flip the desk over.
The easiest way to do this is as follows:
WE RECOMMEND THAT IF YOU DON'T FEEL COMFORTABLE WITH DOING ANY PARTS OF THE
FOLLOWING STEPS THAT YOU GET SOMEONE TO HELP YOU FLIP THE DESK OVER.
Push the desk over so that it stands on the long edge of the desktop that doesn't have
the Control Panel on it.
Grab the opposite sides of the feet and pull back - you want to be careful to do this
slowly as the desk will end up on the edge of the desk and the ends of the metal feet -
we recommend putting something on the ground that you are flipping it on especially if
you have floorboards.
Once in the the following position - walk around to the other side, so you are standing in
the middle of the desktop from here grab the edges and lift up - this step can be broken
into two - the first part being to lift it slightly and sliding something underneath that desk
edge the second part, bending from your knees get your fingers underneath the edge
that is closest to the ground and lift it up, again be mindful that once you get it past a
point that it will start to fall so please take your time in these step.
22
Once the desk is upright - you can go ahead and finish tightening the screws for the
Control Panel, so that it is aligned with the edge of the desk.
23
You can now take the Power Cable (h) and plug this into the Control Box (f) and then to
the most convenient power point in relation to where you would like your desk to sit. We
advise to not bundle and tie up the excess of the power cord, as this excess cord is
required when raising and lowering your desk.
The most important step of all - ENJOY YOUR PREMIUM UPDOWN DESK.
11